184
Chapter 5 Operation
VISERA VIDEO SYSTEM CENTER OTV-S7V
Depending upon the OTV-S7V’s settings, the menu shown in
Figure 5.134 may appear different from that displayed on the
video monitor.
7. Depress the menu switches “ ” or “ ”, or the “///” key on the
keyboard to set the reverse mode.
8. Depress the menu switch “ ” for approximately 1 second or the “Esc” key
on the keyboard to enter settings.
The orientation mode setting is retained when the power is
turned OFF and the power cord is disconnected.
5.29 After use
• Turn the OTV-S7V OFF before connecting or disconnecting
the camera head or videoscope. Connecting or
disconnecting the camera head or videoscope when the
OTV-S7V is ON can damage the camera head’s or
videoscope’s electrical circuits.
• If the OTV-S7V is not going to be used for a long period of
time, disconnect the power cord and isolation transformer
from the wall mains outlet.
1. Turn the OTV-S7V OFF.
2. If any ancillary equipment was used, turn their power switches off according
to their respective instruction manuals.
To Next Page
Loading...
Need help?
General
