Pima Captain 8 Installation Guide

Hunter-Pro Series Captain 8 - Installation Guide
54
Code
Description
ARM
The system was armed
DISAR
The system was disarmed
TST
System test (manually, automatically, or on “wake-up”) performed
6.6. GSM Transmitter
The following menus are displayed only if the “Enhanced Menu” is enabled.
See parameter "P" in section 8.1, on page 62 for details.
Set the GSM-200 cellular communicator's parameters
1
.
6.6.1. GSM Settings
Char.
Parameter
When setting to “+”…
G
GSM TX Installed
The GSM-200 communicator is connected
R
Use Radio ID Account
The radio account ID will be used for the GSM-200 reports
T
Auto Test Report
Test reports will be sent via the GSM-200, in addition to
PSTN reports.
Y
GPRS Encryption
Reports sent via the GSM-200 will be encrypted and sent via
the GPRS channel
S
SMS Backup
The SMS channel will serve as a backup channel to the
GSM-200:
“+”: via SMS messages
“-”: via the Voice channel.
6.6.2. GSM Modes
The GSM-200 cellular module has 2 operating modes that can be used for reporting to two
Monitoring Stations: Mode #1 for Monitoring Station #1, and Mode #2 for Monitoring Station #2.
Each mode has 3 optional channels: Voice, GPRS or SMS
2
.
To set Mode #2 channel, press [ENTR] in the selected Channel screen.
If both Monitoring Stations use the GPRS channel, Mode #2 will be used to report to Monitoring
Station #2.
The DATA channel is not in use. Make sure not to select it.
6.6.3. GSM Phones
Set the Monitoring Station's GSM phone numbers (up to 4). If “Split account number” is enabled (see
section 6.4, on page 51), phone numbers #1 & #2 will be of Monitoring Station #1, phone numbers
#3 & #4 of Monitoring Station #2.
1
To display the GSM-200 version (and the SMS-100 one), press [ENTR] for 2 seconds in the idle screen.
2
The DATA channel is not in use currently

Pima Captain 8 Specifications

General

Brand	Pima
Model	Captain 8
Category	Security System
Language	English