Hunter-Pro Series Captain 8 - Installation Guide
58
Set the events that will be reported to Monitoring Station #2. All parameters are similar to those of
Monitoring Station #1 (see page 50), accept for the radio (“R”): reporting to Monitoring Station #2
via the radio is not available.
6.12. Advanced Programming
The advanced programming menu contains the programming of the cellular providers, the SMS
settings and the network settings.
This menu is not visible by default. To display it, see parameter 'P' in section 8.1, on page 44.
Advanced programming requires professional knowledge in communication
protocols.
Beware not to change the default parameters, unless advised otherwise by the
cellular provider.
6.13. Choose provider
Choose the system's cellular provider. It will be set on the next menu. Up to 5 providers can be
set. The information here should be provided by the cellular provider.
6.14. Cellular providers
The parameters in this menu are described in the following table.
Enter a number only if it should be different from the one in the SIM card
Enter the provider’s APN (Access Point Name). If the text is longer than
16 characters, press [ENTR] and continue to the next blank screen
Continue from previous screen
Enter the service's username. If the text is longer than 16 characters,
press [ENTR] and continue to the next screen.
Continue from previous screen
Enter the service's password. If the text is longer than 16 characters,
press [ENTR] and continue to the next screen
Continue from previous screen
To set other providers, press [NEXT] in the “Cell. Providers1” screen.
6.15. The PSTN SMS center phones
Set the details for the SMS-100 PSTN module.
SMS center OUT: the PSTN SMS center phone no.
SMS center IN: not in use currently
To Next Page
Loading...
Need help?
General
