12.40
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
DIAGNOSTIC PLUG
The diagnostic plug
q
is located under the hood near the
coolant reservoir
w
.
CAN SYSTEM OVERVIEW
The CAN system allows a large amount of information to
flow between components. The CAN system on this
vehicle will link the ECU, Diagnostic Connector,
Instrument Cluster/PIDD and EPS unit through a green
and a yellow wire.
CAN SYSTEM TESTING
A component not displaying information correctly could
be the cause of damaged CAN wiring or a faulty
component.
The easiest location to test the CAN system is at the
Diagnostic Connector.
Turn the key to the OFF position. Using a multimeter,
ohm across the Green and Yellow wires at the diagnostic
connector.
• A RZR equipped with a PIDD should have a reading of
120 Ω. Anything other than 120 Ω is bad.
• A RZR not equipped with a PIDD should see a reading
of 60 Ω. A reading of 120 Ω is bad.
ELECTRICAL
To Next Page
Loading...
Need help?
General
