6 – Port Configuration
Testing a Port
6-16 59263-02 A
S
Display Port Test Results
You can display the test status while the test is in progress by entering the
Test Status Port command in an Admin session as shown in the following
example:
SANbox (admin) #> test status port 1
Port Test Test Loop Test
Num Port Type Status Count Failures
---- -------- ---- ------ ----- --------
1 1 Offline Internal Passed 12 0
Cancel a Port Test
To cancel a port test that is in progress, enter the Test Cancel Port command.
To Next Page
Loading...
Need help?
General
