12 – Call Home Configuration
Managing the Call Home Database
59263-02 A 12-13
A
Adding a Data Capture Configuration
Enter the Capture Add command to add a data capture configuration to the
Tech_Support_Center profile as shown in the following example. If the
Tech_Support_Center profile does not exist, you must create it using the Profile
Create command.
SANbox #> admin start
SANbox (admin) #> callhome edit
SANbox (admin-callhome) #> capture add
A list of attributes with formatting and default values will follow.
Enter a value or simply press the ENTER key to accept the default value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Value (press ENTER to accept the default, 'q' to quit):
TimeOfDay (HH:MM) [02:00]
DayOfWeek (Sun,Mon,Tue,Wed,Thu,Fri,Sat) [Sat ]
Interval (decimal value, 1-26 weeks) [1 ]
A capture entry has been added to profile Tech_Support_Center.
This configuration must be saved with the 'callhome save' command
before it can take effect, or to discard this configuration
use the 'callhome cancel' command.
To Next Page
Loading...
Need help?
General
