5 – Switch Configuration
Displaying Switch Information
59263-02 A 5-5
A
Elapsed Time Between Resets
The Uptime command displays the elapsed time since the switch was last reset
and the reset method. A hot reset or non-disruptive firmware activation does not
reset the elapsed time reported by this command. The following example displays
the time since the last reset.
SANbox #> uptime
Elapsed up time : 0 day(s), 2 hour(s), 28 min(s), 44 sec(s)
Reason last reset: NormalReset
To Next Page
Loading...
Need help?
General
