14 – Command Reference
Command Listing
59263-02 A 14-125
A
logging
Prompts you in a line-by-line fashion to change the event logging configuration
parameters described in Table 14-34. To configure all system parameters, omit
the keyword. For each parameter, enter a new value or press the Enter key to
accept the current value.
ntp
Prompts you in a line-by-line fashion to change the NTP server configuration
parameters described in Table 14-35. To configure all system parameters, omit
the keyword. For each parameter, enter a new value or press the Enter key to
accept the current value.
EthIPv6NetworkMask Ethernet IP subnet mask address.
EthIPv6GatewayAddress Ethernet IP address gateway.
Table 14-34. Event Logging Configuration Parameters
Parameter Description
LocalLogEnabled Enables (True) or disables (False) the saving of log infor-
mation on the switch. The default is True.
RemoteLogEnabled Enables (True) or disables (False) the recording of the
switch event log on a remote host that supports the sys-
log protocol. The default is False.
RemoteLogHostAddress The IP address (version 4 or 6) or DNS host name of the
host that will receive the switch event log information if
remote logging is enabled. The default is 10.0.0.254.
Table 14-35. NTP Server Configuration Parameters
Parameter Description
EthNetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
EthNetworkAddress Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Table 14-33. IP Version 6 Ethernet Configuration Parameters (Continued)
Entry Description
To Next Page
Loading...
Need help?
General
