10 – RADIUS Server Configuration
Configuring a RADIUS Server on the Switch
59263-02 A 10-3
A
Configuring a RADIUS Server on the Switch
Enter the Set Setup Radius command to configure a RADIUS server on the
switch. There are two groups of RADIUS configuration parameters. One group of
parameters is common to all RADIUS server configurations. The second group is
server specific. You can configure both groups of parameters for all RADIUS
servers, or you can configure the common and server-specific parameters
separately. Refer to Table 14-26 for a description of the common and
server-specific RADIUS configuration parameters.
The following example configures the common RADIUS server configuration
parameters:
SANbox (admin) #> set setup radius common
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the attributes
for the server being processed, press 'q' or 'Q' and the ENTER key to do so.
If you wish to terminate the configuration process completely, press 'qq' or
'QQ' and the ENTER key to so do.
PLEASE NOTE:
-----------
* SSL must be enabled in order to configure RADIUS User Authentication
SSL can be enabled using the 'set setup services' command.
Current Values:
DeviceAuthOrder Local
UserAuthOrder Local
TotalServers 1
New Value (press ENTER to not specify value, 'q' to quit):
DeviceAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
UserAuthOrder 1=Local, 2=Radius, 3=RadiusLocal :
TotalServers decimal value, 0-5 :
Do you want to save and activate this radius setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
