14 – Command Reference
Command Listing
14-94 59263-02 A
S
Set Config Security Portbinding
Configures port binding.
Authority Admin session and a Config Edit session
Syntax set config security portbinding [port_number]
Keywords [port_number]
Initiates an editing session in which to change the port binding configuration for
the port given by [port_number]. The system displays each parameter one line at
a time and prompts you for a value. For each parameter, enter a new value or
press the Enter key to accept the current value shown in brackets. Enter “q” or "Q"
to end the editing session. Table 14-21 describes the Set Config Security
Portbinding parameters.
Examples The following is an example of the Set Config Security Portbinding command:
SANbox #> admin start
SANbox (admin) config edit
SANbox (admin-config) #> set config security portbinding 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PortBindingEnabled (True / False)[False] true
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f9
WWN (N=None / WWN)[None ] 10:00:00:c0:dd:00:b9:f8
WWN (N=None / WWN)[None ] n
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
Table 14-21. Port Binding Configuration Parameters
Parameter Description
PortBindingEnabled Enables (True) or disables (False) port binding for the
port given by [port_number].
WWN Worldwide port name for the port/device that is allowed to
connect to the port given by [port_number].
To Next Page
Loading...
Need help?
General
