5 – Switch Configuration
Managing Idle Session Timers
59263-02 A 5-33
A
Managing Idle Session Timers
You can limit the duration of idle login sessions and idle Admin sessions (Admin
Start command). You can specify limits up to 1,440 minutes; specifying 0 means
unlimited. Idle login sessions that exceed the limit are logged off
(InactivityTimeout). An idle Admin session that exceeds the limit is ended, but the
login session may be maintained (AdminTimeout). By default, no limit is enforced
on idle login sessions; idle Admin sessions are ended after 30 minutes.
Enter the Show Setup System Timers command to display the idle login and
Admin session configuration as shown in the following example:
SANbox #> show setup system timers
System Information
------------------
AdminTimeout 30
InactivityTimeout 0
Enter the Set Setup System Timers command to configure idle login and Admin
session limits as shown in the following example:
SANbox (admin) #> set setup system timers
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Current Values:
AdminTimeout 30
InactivityTimeout 0
New Value (press ENTER to accept current value, 'q' to quit):
AdminTimeout (dec value 0-1440 minutes, 0=never) :
InactivityTimeout (dec value 0-1440 minutes, 0=never) :
Do you want to save and activate this system setup? (y/n): [n]
To Next Page
Loading...
Need help?
General
