14 – Command Reference
Command Listing
59263-02 A 14-207
A
Zone
Manages zones and zone membership on a switch.
Authority Admin session and a Zoning Edit session. Refer to the “Zoning Edit” command on
page 14-218 for information about starting a Zoning Edit session. The List,
Members, and Zonesets keywords are available without an Admin session.
Syntax zone
add [zone] [member_list]
list
members [zone]
orphans
remove [zone] [member_list]
rename [zone_old] [zone_new]
zonesets [zone]
Keywords add [zone] [member_list]
Specifies one or more ports/devices given by [members] to add to the zone
named [zone]. Use a <space> to delimit aliases and ports/devices in
[member_list]. A zone can have a maximum of 2000 members. [member_list] can
have any of the following formats:
Domain ID and port number pair (Domain ID, Port Number). Domain IDs can
be 1–239; port numbers can be 0–255.
6-character hexadecimal device Fibre Channel address (hex)
16-character hexadecimal worldwide port name (WWPN) with the format
xx:xx:xx:xx:xx:xx:xx:xx.
Alias name
The application verifies that the [members] format is correct, but does not validate
that such a member exists. You must enter the Zoning Save command afterwards
to save your changes.
copy [zone_source] [zone_destination]
Creates a new zone named [zone_destination] and copies the membership into it
from the zone given by [zone_source]. You must enter the Zoning Save command
afterwards to save your changes.
create [zone]
Creates a zone with the name given by [zone]. An zone name must begin with a
letter and be no longer than 64 characters. Valid characters are 0-9, A-Z, a-z, _, $,
^, and -. The zoning database supports a maximum of 2000 zones. You must
enter the Zoning Save command afterwards to save your changes.
To Next Page
Loading...
Need help?
General
