14 – Command Reference
Command Listing
14-92 59263-02 A
S
Set Config Security
Configures the security database for the automatic saving of changes to the active
security set and fabric binding. The changes you make with this command are not
retained when you reset or power cycle the switch unless you save them using the
Config Save command.
Authority Admin session and a Config Edit session
Syntax set config security
This command initiates an editing session in which to change the security
database configuration. The system displays each parameter one line at a time
and prompts you for a value. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter “q” or "Q" to end
the editing session. Table 14-20 describes the security configuration parameters.
NOTE:
This command requires the Fabric Security license key. To purchase a
license key, contact your authorized maintenance provider or authorized
reseller. Use the Feature command to install a license key.
Table 14-20. Security Configuration Parameters
Parameter Description
AutoSave Enables (True) or disables (False) the saving of changes
to active security set in the switch’s permanent memory.
The default is True.
FabricBindingEnabled Enables (True) or disables (False) the configuration and
enforcement of fabric binding on all switches in the fabric.
Fabric binding associates switch worldwide names with a
domain ID in the creation of ISL groups. The default is
False.
To Next Page
Loading...
Need help?
General
