14 – Command Reference
Command Listing
14-196 59263-02 A
S
Notes Table 14-44 describes the port test parameters.
To cancel a port test that is in progress, enter the Test Cancel Port command.
To display the status of the most recent port test or port test in progress, enter the
Test Status Port command.
Table 14-44. Port Test Parameters
Parameter Description
LoopCount Number of frames sent
FrameSize Number of bytes in each test frame
DataPattern Pattern in the payload
StopOnError Stops the test when an error occurs (True).
Otherwise, the test continues to comple-
tion.
LoopForever Restarts the test after completion and con-
tinues until you cancel it (True). Otherwise,
the test ends normally after completion.
To Next Page
Loading...
Need help?
General
