9 – Device Security Configuration
Modifying the Security Database
59263-02 A 9-9
A
Modifying the Security Database
To modify the security database, you must open an Admin session with the Admin
Start command. An Admin session prevents other accounts from making changes
at the same time either through the CLI, QuickTools, or Enterprise Fabric Suite
2007. You must also open a Security Edit session with the Security Edit
command. The Security Edit session provides access to the Securityset, Group,
and Security commands with which you make modifications to the security
database.
SANbox #> admin start
SANbox (admin) #> security edit
SANbox (admin-security)#> securityset . . .
SANbox (admin-security)#> group . . .
SANbox (admin-security)#> security . . .
When you are finished making changes, enter the Security Save command to
save the changes and close the Security Edit session.
SANbox (admin-security)#> security save
To close the session without saving changes, enter the Security Cancel
command.
SANbox (admin-security)#> security cancel
Changes to the active security set do not take effect until you activate it with the
Security Activate command. The Admin End command releases the Admin
session for other administrators when you are done making changes to the
switch.
SANbox (admin)#> security activate
SANbox (admin)#> admin end
To Next Page
Loading...
Need help?
General
