Chapter 6: Performing Library Operations
Shutting Down, Restarting, Turning Off, and Removing Power
Quantum Scalar i40 and Scalar i80 User’s Guide 139
Web Client
1 Click the Logout button in the upper right corner of the screen,
or select Operations > Log
Out.
2 Click OK to
confirm.
Shutting Down, Restarting, Turning Off, and
Removing Power
It is important to shut down the library properly before turning off the
library or completely removing library power.
Caution: You should always perform a shutdown before turning off
the library or completely removing power. Otherwise, the
following could occur:
– The library may not complete closing all data and log
files.
– If you turn off power or unplug the power cord while
writing to tape, the data on
the tape could become
corrupted.
– If you unplug the power cord, the robot may
become frozen in the middle of an operation and unable
to move once library power is restor
ed, possibly
requiring a service call.
The steps for shutting down, turning off, and completely removing
library power are:
1 Make
sure the connected host applications are not sending
commands to the library and that all library operations have
stopped.
2 Shut down
the library using the operator panel or Web client (see
Shutting Down the Library on page 140).
3 Tu
rn OFF the library by pressing the power button on the front
panel (see
Turning Off the Library on page 143).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
