Quantum Scalar i80 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Connecting Library Cables
Quantum Scalar i40 and Scalar i80 User’s Guide 227
Connecting Library Cables
Connect the cords and cables as follows (see Figure 42 on page 228). It
is recommended that you leave some slack in the cables to allow you to
perform certain replacement procedures in the future.
1 Connect the tape drive cables from the tape drives to the host.
Caution: Use care when handling the fibre optic cables. Do not
crimp or bend the cables. Do not exceed the bend
radius specified by the manufacturer.
2 Connect an Ethernet cable (not supplied with your library) into the
LEFT port on the system control board (SCB). The right SCB port is
for service use only; do not use. Connect the other end of the
Ethernet cable into a live Ethernet jack connected to your network.
3 Connect the power supply cord into the power supply connector.
Plug the other end of the cord into a grounded AC outlet.

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g