Quantum Scalar i80 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Replacing the Chassis
Quantum Scalar i40 and Scalar i80 User’s Guide 259
Procedure When you replace a library chassis, you will remove all the components
from your existing library and install them in the new library.
1 Unpack the new library chassis and place it on a flat, level surface.
See the instructions in
Chapter 2, Unpacking the Library for specific
unpacking instructions, particularly about removing the Y-tray
restraints.
2 Verify that the new chassis is the same type (Scalar
®
i40 or Scalar
i80) as the unit you are replacing.
3 If you had license keys installed on your library, you will need to
install new ones on the replacement library. Contact Quantum
Support to request new license keys.
4 If the library you are replacing is still turned on and operational,
shut down the library by selecting Actions > Shutdown from the
operator panel.
5 Turn OFF the library by pressing the power button on the front
panel.
6 Disconnect the power supply cord, the Ethernet cable, and all tape
drive cables from the back of the library. If you have multiple tape
drives, label the cables so you can reconnect them to the correct
tape drives later.
7 Remove all of the following components from the library (see
Figure 60 on page 261).
Component to
Remove
Instructions
Power Supplies
Caution: Make sure the power supply is unplugged and disconnected
from live power before you remove it.
1 Disconnect the power cord from the back of the power supply.
2 Unscrew the captive thumbscrews.
3 Pull outward on the power supply handle to remove it from the library.
System Control
Board (SCB)
1 Loosen the two captive thumbscrews on the SCB.
2 Grip the thumbscrews and pull outward to slide the SCB out of the library.
3 Place the SCB on an anti-static surface or in an anti-static bag.

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g