Quantum Scalar i80 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing the Library from a Desktop Kit
252 Quantum Scalar i40 and Scalar i80 User’s Guide
8 Install the top cover as follows (see Figure 56):
a Slide the
top cover onto the library, from back to front. The back
of the top cover has two screw holes and overhangs the back of
the library.
b Install the two top cover screws through the top cover and into
the screw holes in the top of
the side panels.
Figure 56 Installing Top Cover
9 Re-install the magazines and push them in until they close.
10 Re-in
stall tape drives if you removed them previously.
11 Conne
ct the tape drive cables, Ethernet cable, and power cord (see
Connecting Library Cables on page 227).
Removing the Library from a Desktop Kit
To remove the library from a desktop kit, reverse the steps in Installing
the Library in a Desktop Kit on page 244.

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g