Replacing Photo Conductor Unit (PCU)
95
3
Replacing Photo Conductor Unit (PCU)
When "Replace photoconductor unit" appears on the panel display, it is time to
replace the photo conductor unit.
WARNING:
Note
❒
Do not tilt used PCU after removing it from the machine. If you do, toner
might fall out.
❒
Do not hold the developer cartridge when removing the used PCU from your
machine. If you do, the cartridge might come unlocked and fall.
❒
Do not touch the photo conductor. If you do, abnormal copies might be made.
❒
Before you remove the used PCU from the machine, wait until the machine
has completely stopped and is making no sound. Failure to take this precau-
tion could result in a fault.
❒
If there are misfeeds, remove the misfed paper before removing the used
PCU.
❒
Be sure to remove the sealing tape before setting the new PCU. Leaving it on
could cause a fault.
❒
After replacing the PCU, the machine will take about 1 minutes to initialize.
• Do not incinerate the photo conductor unit. Toner dust might ignite when exposed
to an open flame. Dispose of the used photo conductor unit according to local reg-
ulations for plastics.
To Next Page
Loading...
Need help?
General
