Copying
48
2
Note
❒
The previous copy settings are
recalled and the previous copy
job can be resumed by pressing
the
{
Start
}
key.
Interrupting copying after all
originals have been fed
A Press the
{
Interrupt
}
key.
The Interrupt key lights and copy-
ing will stop.
B Set your original.
Reference
For functions that cannot be
used together with this func-
tion, see
⇒
P.80
“Combination
Chart”
.
C Press the
{
Start
}
key.
The machine starts making your
copies.
D When copying is complete, re-
move your originals and copies.
E Press the
{
Interrupt
}
key again.
The Interrupt indicator goes out.
F Press the
{
Start
}
key.
The previous copy job settings will
be restored and the machine will
continue copying from where it
left off.
User Codes
When user codes are turned on, oper-
ators must input their user codes be-
fore the machine can be operated. The
machine keeps count of the number
of copies made under each user code.
Note
❒
When user codes are turned on,
the machine will prompt you for
your user code after the power
switch is turned on or System Re-
set comes into effect.
❒
To prevent others from making
copies using your user code, press
the
{
Clear Modes
}
and
{
Clear/Stop
}
keys simultaneously after copying.
Reference
For setting user codes, see
⇒
P.119
“1. General Features
4
/
4
”
.
Auto Start—Entering Copy
Job Settings During the Warm-
up Period
If you press the
{
Start
}
key during the
warm-up period, the
{
Start
}
key will
blink and your copies will be made as
soon as warm-up finishes.
A Make any adjustments to copy
settings during the warm-up peri-
od.
B Set your originals.
C Press the
{
Start
}
key.
The
{
Start
}
key indicator alternate-
ly flashes red and green.
Note
❒
To cancel Auto Start, press the
{
Clear/Stop
}
key.
Original Tone
The key tone sounds and an error
message is displayed when you leave
your originals on the exposure glass
for about two seconds after copying.
To Next Page
Loading...
Need help?
General
