Upload/Download
In this service manual, "upload" and "download" have these meanings:
• Upload: Copying data from the printer to the SD card
• Download: Copying data from the SD card to the printer
Network Connection
A print job sent to the machine during firmware update will interrupt the procedure. Before you start the
firmware update procedure tell the operator:
• The machine must be disconnected from the network.
• The machine cannot be used during firmware update.
Machine Firmware Update
Each program must be updated one a time. Follow the procedure below to update one program.
1. Prepare a card that contains the required program.
2. If the machine is on, switch it off.
3. Remove the SD card cover (x1).
4. Insert the SD card into Slot 2.
5. Turn on the power. The screen remains blank for about 20 to 30 sec., "Please Wait" appears, then
you will see "Engine", the first item available for selection.
5. Service Tables
146
To Next Page
Loading...
Need help?
General
