Recording a Pattern
125125
4. Use TARGET to select the performance data to
input.
5. Touch <DRAW> to turn it on.
6. Touch < > (Pencil).
7. Input performance data by tracing your nger on
the grid.
This inputs the performance data.
Selecting Multiple Notes
In the piano roll screen, you can now select multiple notes.
1. In the PATTERN screen, select the pattern that you
want to edit, and then press the [E3] EDIT.
The EDIT SELECT screen appears.
2. Select <PIANO ROLL>.
The PIANO ROLL screen appears.
3. Touch a note.
The note you touch is selected.
4. Hold down the [SHIFT] button and touch a
dierent note.
The note is additionally selected.
5. By holding down the [SHIFT] button and dragging
over the grid, multiple notes in that area can be
selected in a single operation.
drag
MEMO
By holding down the [SHIFT] button and touching a selected note,
you can clear the selection of the note that you touched.
Dragging a Note to Copy It
A note selected in the piano roll screen can be copied by dragging
it.
1. In the PATTERN screen, select the pattern that you
want to edit, and then press the [E3] EDIT.
The EDIT SELECT screen appears.
2. Select <PIANO ROLL>.
The PIANO ROLL screen appears.
3. Touch the note that you want to copy, selecting it.
You can also select multiple notes as described in “Selecting
Multiple Notes”.
4. While pressing the [E6] knob located at the lower
right of the screen, drag the selected note to
another location.
Now you’re in the copy-destination selection state, and the
note you’re dragging is shown as semi-transparent.
Drag the selected note
While pressing the [E6] knob
5. When you decide on the copy-destination and
release the nger that you were dragging.
The copy is nalized.
MEMO
Instead of dragging the note, you can also hold down the [E6] knob
and use the cursor [à] [á] [ã] [â] buttons to move the position.
When you take your nger o the [E6] knob, the copy is nalized.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
