Siemens SINAMICS V90 User Manual

Basic operator panel (BOP)
6.5 Auxiliary functions
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
201
6.5.2
Saving parameters (RAM to ROM)
This function is used for saving a parameter set from the drive RAM to drive ROM. To use
this function, proceed as follows.
Note
Plugging or unplugging the micro SD card/SD card will cause saving failure.
Do not plug or unplug the micro SD card/SD card during saving; otherwise, the saving
operation will fail.
Note
•
If a micro SD card/SD card has been inserted, the parameter set will be saved onto the
micro SD card/SD card simultaneously.
•
All signal functions become inactive during the saving process. Use the signal functions
afterwards.
Reference
Editing parameters (Page 196)

Siemens SINAMICS V90 Specifications

General

Power Range	0.05 kW to 7.0 kW
Protection Class	IP20
Communication	USS/Modbus RTU
Feedback	Incremental encoder
Input Voltage	1AC 200 V to 240 V, 3AC 380 V to 480 V
Control Modes	Position, Speed, Torque
Operating Temperature	0 °C to +40°C
Storage Temperature	-40°C to +70°C
Relative Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000 m above sea level