Siemens SINAMICS V90 User Manual

General information
2.5 Accessories
SINAMICS V90, SIMOTICS S-1FL6
58 Operating Instructions, 04/2019, A5E36037884-007
2.5.8
Micro SD card/SD card
Optionally you can use a micro SD card/SD card to copy drive parameters or perform a
firmware update. Micro SD card is used for the 200 V variant servo drive and SD card is
used for the 400 V variant servo drive. Siemens recommends you to use the Siemens SD
card (article number: 6SL3054-4AG00-2AA0).
● For the servo drives with firmware version V1.04.00 or higher, you can select high quality
micro SD cards/SD cards with a maximum capacity of 32 GB from manufacturers such as
Kingston or SanDisk.
● For the servo drives with earlier firmware version, you can select high quality micro SD
cards/SD cards with a maximum capacity of 2 GB from manufacturers such as KINGMAX,
Kingston or SanDisk.
2.5.9
Replacement fans
The table below lists the replacement fans for SINAMICS V90 servo drives.
SINAMICS V90
Article number
3-phase, 200 VAC to 240 VAC
FSD 6SL3200-0WF00-0AA0
3-phase, 380 VAC to 480 VAC
FSB 6SL3200-0WF00-0AA0
FSC
6SL3200-0WF01-0AA0

Siemens SINAMICS V90 Specifications

General

Power Range	0.05 kW to 7.0 kW
Protection Class	IP20
Communication	USS/Modbus RTU
Feedback	Incremental encoder
Input Voltage	1AC 200 V to 240 V, 3AC 380 V to 480 V
Control Modes	Position, Speed, Torque
Operating Temperature	0 °C to +40°C
Storage Temperature	-40°C to +70°C
Relative Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000 m above sea level