Scale parameters and functions
8.29 DR 32 Error messages
SIWAREX WP251
146 Manual, 12/2015, A5E37203357A
The individual error messages are presented and explained in detail in section "Messages"
(see Errors and messages (Page 163)). The following table is used only for breaking down
the individual messages into their message bits.
Table 8- 29 Assignment of data record 32
Contains no. of the data record
Length
Data record length information
USHORT
2
r
32
-
-
3501
Application
Information on application to
USHORT
2
r
105
-
-
3502
Version identifier
Current data record version in-
USHORT
2
r
1
1
65535
3503
1000 Operating error There is at least one operating
error (=1 as long as an operating
Bit_0 0 r 0 - - 3504
1003 Checksum error (pa-
Checksum error in parameters Bit_3 0 r 0 - - 3504
1004 Checksum error (pro-
Checksum error in program code Bit_4 0 r 0 - - 3504
Log book is full or defective
Analog-to-digital converter error
1104 Undervoltage Undervoltage at SENSE input Bit_10 0 r 0 - - 3504
1107 SecureDisplay failure Connection to SecureDisplay has
Bit_13 0 r 0 - - 3504
2000 Technological error At least one technology error
Bit_0 0 r 0 - - 3505
2001 Timeout tare or zero
setting
Taring or zero setting is not pos-
sible because a standstill was not
reached during the standstill wait-
Bit_1 0 r 0 - - 3505
2002 Trace error The configured cycle for the trace
recording cannot be processed:
Reading is active or buffer is full;
Bit_2 0 r 0 - - 3505
To Next Page
Loading...
Need help?
General
