Siemens SIWAREX WP251 User Manual

SIWAREX WP251
Manual, 12/2015, A5E37203357A
179
Command lists
10
10.1
Overview
The commands for the electronic weighing system described here can be transmitted by
several interfaces:
● by the Operator Panel via the controller to the SIWAREX module
● by the operator panel directly to the SIWAREX module via Modbus
● by SIWATOOL directly to the SIWAREX module
● by the digital inputs after corresponding assignment in data record DR 7
If an issued command is not accepted by SIWAREX, the cause of the rejection is always
substantiated with a corresponding data/operating error.
Detailed descriptions of the commands can be found in the following command lists:
→ Table 10-1 Table 10-1 Service commands (Page 180)
→ Table 10-2 Table 10-2 Protocol commands, statistics, logbook (Page 181)
→ Table 10-3 Table 10-3 Trace commands (Page 181)
→ Table 10-4 Table 10-4 Display changeover for DR 34 and SecureDisplay (Page 181)
→ Table 10-5 Table 10-5 Scale commands (Page 183)
→ Table 10-6 Table 10-6 Scale commands (Page 183)
See also
Command lists (Page 179)
10.2
Command lists
The commands for the electronic weighing system described here can be transmitted by
several interfaces:
● by the Operator Panel via the controller to the SIWAREX module
● by the Operator Panel directly to the SIWAREX module
● by SIWATOOL directly to the SIWAREX module
● by the digital inputs after corresponding assignment in data record DR 7

Siemens SIWAREX WP251 Specifications

General

Brand	Siemens
Model	SIWAREX WP251
Category	Accessories
Language	English