Siemens SIWAREX WP251 User Manual

Errors and messages
9.6 Operating errors
SIWAREX WP251
172 Manual, 12/2015, A5E37203357A
9.6.4
Data and command errors - Additional information
Additional information is available for most data/command errors. The cause of the error is
described in detail with this information. If a data/command error bit is set, the additional
information is also filled accordingly. Thus, the error bits and the additional information must
be evaluated together in the program to identify the exact cause of the error.
If additional information not listed above appears for a data/operating error bit, it is a
parameter ID. This defines the exact parameter that caused the error.
The following table presents the association between the parameter and parameter ID.
Parameter
Data record
Parameter ID
Standstill 1 - range
3
2153
Standstill 2 - range 3 2154
Standstill 1 - time
3
2158
Standstill 2 - time
3
2159
Weighing operating mode
3
2503
Automatic zero tracking
3
3063
Calibration digits 0 (measured)
3
3081
Calibration digits 1 (measured)
3
3083
Calibration digits 2 (measured)
3
3085
Calibration weight 0
3
3086
Calibration weight 1
3
3087
Calibration weight 2
3
3088
Depth average filter
3
3137
Frequency low pass filter 1
3
3175
SecureDisplay version
3
3178
SecureDisplay interface
3
3197
Gross indicator
3
3199
Maximum weight
3
3217
Minimum weight
3
3219
Order no. low pass filter 1
3
3236
Automatic zero tracking in dosing cycle 3 3247
Resolution
3
3248
Restriction code
3
3249
Scale name
3
3256
Additive tare
3
3282
Grid frequency
3
3283
Tare maximum
3
3288
Max. waiting time for standstill 1
3
3316
Weight simulation allowed
3
3322
Weight unit
3
3323
Initial zeroing
3
3329
Initial zeroing if tared
3
3330
Negative zeroing limit (initial zeroing)
3
3332

Siemens SIWAREX WP251 Specifications

General

Brand	Siemens
Model	SIWAREX WP251
Category	Accessories
Language	English