Frame Memory Clip Operations
Recalling Clips
Recalling a clip
You can recall a clip from each of frame memories 1 to 8.
1 Open the Frame Memory >Clip >Recall menu (2521).
When [Pair] is on, only pair files (each consisting of a
main file and a sub file) are displayed.
When [Pair] is set to off, both single files and pair files
are shown.
To recall in direct recall mode
Direct recall means that pressing a thumbnail immediately
recalls the file.
In this mode, only the front thumbnail file is recalled.
1
In step
6
of “Recalling a clip”
(
1
p. 136), instead of
pressing [Recall], press [Direct Recall].
2
Press the thumbnail for the file you want to recall.
To display the sub file in front
While direct recall mode is on, press [Sub Display],
turning it on.
Frame memory
selection area
Target selection buttons
Pair selection buttons
Frame memory folder
selection area
To search the clip file by file name
Press [Find]. Perform the same operation as for still images
(
1
p. 132).
Clip Playback
You can play a recalled clip by a menu operation or by
using the device control block.
Notes
With a pair file recalled, it is possible to set [Pair] to off
and carry out a single file operation, but if you then set
[Pair] to on again, the output of frame memory may be
black. In such cases, it is necessary to recall the pair file
once more.
Clip file selection area
[Find] button
[Direct Recall]
button
Playing a clip using the menu
1 Open the Frame Memory >Clip >Play menu (2522).
2
In the frame memory selection area, select the frame
memory to be assigned
(
1
p. 130).
3
If [Direct Recall] is on, press it to turn it off.
4
In the frame memory folder selection area, select the
desired folder.
By pressing [More] to switch the display, you can
select from a maximum of 12 folders.
5
Press the thumbnail of the clip you want to recall.
6
Press [Recall].
This recalls the clip file, which is assigned to the FM
you selected in step 2.
In pair mode, if a clip is selected, the main file is output
to FM1, and the sub file to FM2. In single mode, when
only one of FM1 and FM2 is selected, the front file on
the thumbnail is output.
The status of the clip shown in the current target FM
selection buttons appears.
To Next Page
Loading...
Need help?
General
