Procedure for Basic Transition Operation
Chapter
3
Signal
Selection
and
Transitions
Independent
key
transition
Linked to a mix
(dissolve) or wipe
transition, a frame
memory clip (movie) is
played back.
The new video quickly
cuts into and replaces
the current video.
Procedure for Basic
Transition Operation
Key priority display
Next transition selection buttons
Transition type selection buttons
Transition rate display
Transition control block
1
In the background A row of the cross-point control
block, select the background video.
2
Select the way in which the transition will affect the
image, using the next transition selection buttons in the
transition control block.
To change the background: Press the [BKGD]
button, turning it on.
To insert or delete a key: Press one of the [KEY1] to
[KEY4] buttons (or [DSK1] to [DSK4] buttons in
the PGM/PST bank), turning it on.
To enable the key priority setting, which
determines the key overlay order after the
transition: Press the [KEY PRIOR] button,
turning it on.
You can press more than one button at the same time.
To change preset keys and backgrounds
simultaneously: Press the [ALL] button.
For details about allocating a particular next
transition button to the [ALL] button function,
1
“Setting the Operation Mode of the [ALL] Button
in the Transition Control Block” (p. 342).
3
For the transition to change the key priority, set the
priority for after the transition.
For details about operations,
1
“Key Priority
Setting” (p. 65).
For details about using keys 1 to 8,
1
“Setting the
DSK1 to DSK8 Key Priority” (p. 414).
4
Select the new video used for the transition.
•
In the background B row of cross-point buttons,
select the new background video.
•
When inserting a key, select the key signal, and
make any required settings.
For details about key settings,
1
“Keys” (p. 79).
To carry out a cut transition, skip to step 7; otherwise
continue to step 5.
5
Select one of the transition type selection buttons in
the transition control block.
To carry out a dissolve to the new video: Press one
of the [MIX], [NAM], [SUPER MIX], and [PST
COLOR MIX] buttons, turning it on.
To carry out a wipe: Press the [WIPE] or [DME]
button, turning it on.
To carry out a transition while playing back a
frame memory clip: Press one of the buttons
corresponding to the clip to be used
(FM1&2CLIP, FM3&4CLIP, FM5&6CLIP, and
FM7&8CLIP), turning it on.
You can also use the Misc >Transition menu (1171) to
select a desired transition type for a switcher bank.
Notes
The transition type selection buttons in the transition
control block can be interchanged in the Setup menu.
For details,
1
“Setting Transition Control Block
Button Assignments” (p. 327).
6
Make the required settings, according to the selected
transition type.
Super mix:
“Super Mix Settings”
(
1
p. 67)
To Next Page
Loading...
Need help?
General
