Managing Images Using a DDR/VTR 143
3
In the <Backup> group, perform one of the following.
•
To replace the existing data, press [Replace].
•
To save in addition to the existing data, press
[Append].
Notes
When you execute [Replace], all of the saved files in
the logical drive are erased immediately before the
saving operations.
4
Check the message, then press [Yes].
This starts the file saving operation. If there is no
directory, a directory is automatically created, and the
files are saved within it.
5
Check the message, then press [OK].
To rename a directory
Select a directory in the list, and press [Rename].
In the keyboard window, enter the new directory name,
and press [Enter]. The name of a directory is limited to
eight characters.
Notes
The following names cannot be used:
CON, PRN, AUX, CLOCK$, NUL
COM0, COM1, COM2, COM3, COM4, COM5, COM6,
COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7,
LPT8, LPT9
Recalling Files
You can recall all of the saved files on the HDD into frame
memory.
1
Carry out steps
1
and
2
in “Saving Files”
(
1
p. 142).
Notes
It is not possible to select a partition (FMHDD1 to
FMHDD15) of an HDD in which no file is saved.
2
In the <Restore> group, perform one of the following.
•
To replace the existing data with the recalled data,
press [Replace].
•
To add the recalled data to the existing data, press
[Append].
Notes
When you execute [Replace], any existing data in
frame memory is lost immediately before the recalling
operations.
3
Check the message, then press [Yes].
This starts the file recall operation.
4
Check the message, then press [OK].
Managing Images Using a
DDR/VTR
Using a DDR/VTR for High-speed
Backup and Restoring
You can save all files currently held in frame memory as a
single backup data set, by high-speed recording on video
tape or other medium.
To restore the folder structure, it is necessary to save the
automatically generated file list (of file name, length of
clip, and so on) in memory.
Notes
At the beginning of this backup data a red or blue image is
automatically inserted when the data is created. Do not
delete this image, as it is required for restoring the data.
High-speed recording of backup data to
DDR or VTR
Notes
Before starting the backup, it is necessary to select the FM
output to record on an AUX bus, for example, and input
the AUX output to the DDR/VTR.
1
Open the Frame Memory >External Device >Backup
to DDR/VTR menu (2564).
2
To save with ancillary data, output the frame memory
output signal to the AUX bus.
3
Press [Backup Enable], turning it on.
4
Press [Backup Start].
5
Start recording on the external device, and
immediately after that press [Yes].
To Next Page
Loading...
Need help?
General
