2-16. DPR-355 Board
Preparation
1. Remove the bottom panel assembly. (Refer to “2-5. Bottom Panel Assembly”)
2. Remove the inside panel assembly. (Refer to “2-6-1. Inside Panel Assembly”)
3. Remove the outside panel assembly. (Refer to “2-7-1. Outside Panel Assembly”)
4. Remove the rear panel assembly. (Refer to “2-8. Rear Panel Assembly”)
5. Remove the handle assembly. (Refer to “2-11-1. Handle Assembly”)
6. Remove the IO block. (Refer to “2-10. IO Block”)
7. Remove the front lens assembly. (Refer to “2-15. Front Lens Assembly”)
8. Remove the DCP-64 board. (Refer to “2-14. DCP-64 Board”)
Procedure
1. Remove the three screws to detach the USB bracket.
2. Remove the five screws to detach the heat spreader DPR.
3. Remove the DPR-355 board from the connector on the AU-357 board.
4. Disconnect the four fine-wire coaxial cables from the four connectors on the DPR-355 board.
P2 x 4
DPR-355 board
Fine-wire coaxial cables
Fine-wire coaxial cables
Connectors
Connectors
Connector
(AU-357 board)
USB bracket
Hole
Hole
Heat spreader DPR
P2 x 4
P2 x 4
Bosses
Note
When installing the USB bracket, fit the two bosses with the two holes.
5. Install the removed parts by reversing the steps of removal.
PMW-300
2-48
To Next Page
Loading...
Need help?
General
