8-46 CHASSIS
REMOVAL
• Remove the drive chain case 1.
• Remove the torque link nut (rear) 2, brake adjuster nut 3,
pin 4, spring 5 and washer 6.
NOTE:
When removing the brake rod, depressing the brake pedal.
• Remove the rear axle nut 7.
• Raise the rear wheel off the ground and support the motorcy-
cle with a jack or a wooden block.

• Loosen the both chain adjuster lock-nuts 8.
• Loosen the both chain adjuster bolts 9.
• Remove the rear axle 0 and disengage the drive chain A
from the rear sprocket.
• Remove the rear wheel B.
• Remove the left and right spacers (C, D).
Make sure that the motorcycle is supported securely.
To Next Page
Loading...
Need help?
General
