SERVICING INFORMATION 10-19
CYLINDER HEAD RUBBER PAD INSTALLATION
NOTE:
Insert the rubber pads at 0 – 4 mm (0 – 0.16 in) depth from the fin ends.
EXHAUST SYSTEM CONSTRUCTION
A 40 mm (1.6 in) C 118 – 122 mm (4.6 – 4.8 in) E 70.5 – 72.5 mm (2.78 – 2.85 in)
B 46 mm (1.8 in) D 32 – 34 mm (1.26 – 1.34 in)
1 Exhaust pipe gasket 4 Muffler connector
2 Exhaust pipe cover 5 Muffler cover
3 HO2 sensor *1 The tip of clamp must face inside of the exhaust pipe cover.
DIRECTION
OF RUBBER
PAD INSERT
DIRECTION OF RUBBER
PAD INSERT
50 N
.
m (5.0 kgf-m, 36.0 lbf-ft)
23 N
.
m (2.3 kgf-m, 16.5 lbf-ft)
25 N
.
m
(2.5 kgf-m,
18.0 lbf-ft)
*1
23 N
.
m
(2.3 kgf-m, 16.5 lbf-ft)
4 N
.
m (0.4 kgf-m, 3.0 lbf-ft)
23 N
.
m
(2.3 kgf-m, 16.5 lbf-ft)
20 – 30˚
To Next Page
Loading...
Need help?
General
