To use
1. Connect the logic probe to the instrument.
2. Connect the probe to the input signal sources.
CAUTION.
To prevent damage to the instrument always wear an antistatic wrist strap when making connections to the instrument and
observe the maximum input voltage ratings for input connectors.
3. Set up digital channels and buses using the Digital Setup and Bus Setup control windows through the Digital menu. The Bus
Setup window is also accessible through the Vertical menu.
What do you want to do next?
Learn about setting up the digital channels.
Learn about bus setups.
Learn about bus configuration.
Digital channel threshold and position
NOTE. The Digital Channel Threshold and Position option is available only on MSO5000B and MSO70000C/DX Series
instruments and DPO5000B Series instruments with option MSOE installed, and DPO70000DX instruments with option MSOU
installed.
From the Digital menu, select Digital Setup.
Overview
Use these controls to define the voltage threshold level of digital channels and their vertical position in the display.
Digital setups
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 101
To Next Page
Loading...
Need help?
General
