Uponor Smatrix Base User Manual

15.5 Restore from backup (Base PRO
only)
If an existing Uponor Smatrix Base PRO controller has
been replaced, installation data (including thermostat
registration data) from the replaced controller can be
reused to setup the new controller.
Caution!
Make sure the controller is powered off
before ejecting the microSD card.
NOTE!
When replacing a controller, the microSD card
from the replaced unit must be used in the
new controller. Otherwise all registrations
must be redone.
NOTE!
When a controller has been replaced, no
additional units can be added to the system
without redoing the whole installation.
Replace the microSD card with the new one
again, or format the existing one, and redo
the installation procedure with the additional
units.
1 3 4
Preparation
1. Eject the microSD card from the malfunctioning
controller.
Restore from backup to new controller
2. Power off the new controller.
3. Eject the existing microSD card from the new
controller.
4. Insert the microSD card containing the installation
data from the malfunctioning controller into the
new one.
5. Power on the new controller.
The new controller is now setup with the installation
data from the malfunctioning one.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
114
UPONOR SMATRIX BASE/BASE PRO · INSTALLATION AND OPERATION MANUAL

Uponor Smatrix Base Specifications

General

Brand	Uponor
Model	Smatrix Base
Category	Heating System
Language	English