Uponor Smatrix Base User Manual

12.4 Start up
When starting up, the software version is shown in the
display for about three seconds. Then the thermostat
enters run mode.
The first time the thermostat is started, or after a
factory reset, the software requires the time and date to
be set (T-148 only).
softWare version
Current software version is displayed when the
thermostat is powered on.
Examples:
T-149
V1.0
T-146
T-148
set t ime an d date (t-148 only)
When starting the thermostat for the first time, or after
a factory reset, the software requires the time and date
to be set.
Use buttons - or + to change the value, press the OK
button to set the value and move to the next editable
value.
NOTE!
If no button is pressed for about 8 seconds,
the current values will be saved and the
software exits to run mode.
1. Set hours.
2. Set minutes.
3. Set 12 h or 24 h display of time.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
80
UPONOR SMATRIX BASE/BASE PRO · INSTALLATION AND OPERATION MANUAL

Uponor Smatrix Base Specifications

General

Brand	Uponor
Model	Smatrix Base
Category	Heating System
Language	English