The illustration below shows how to remove the slave
module from the controller.
1
1.2 mm
8 mm
2
1. Place a wide flat head screwdriver in the slot
between the slave module and the other unit and
twist until one side has popped of. Repeat for the
other side.
2. Remove the slave module. Use caution not to bend
the connection pins.
5.4 Connect the star module (optional)
The star module can be connected to the controller by
either snapping it into place or connecting it using a
cable.
NOTE!
Only one star module extension is supported
per Uponor Smatrix Base controller.
NOTE!
Only one star module extension per bus type
(thermostat and/or system bus) is supported
per Uponor Smatrix Base PRO controller.
A star module can only be used for one bus
type at a time. That is, a thermostat cannot
be connected to a star module connected to
the system bus and vice versa.
The illustration below shows how to snap the star
module into place direct to the controller or an optional
slave module.
To Next Page
Loading...
Need help?
General
