Uponor Smatrix Base User Manual

6
T-143
5 s
7
8
4
8
3 s
NOTE!
Registration of at least one thermostat must
be done before registering a system device.
NOTE!
If registering a public thermostat T-143 as
a system device with various functions, the
thermostat only acts as a remote unit. It does
not control the room temperature in the room
where it is placed.
Caution!
The DIP switches in public thermostat
T-143 must be set before the thermostat is
registered.
Caution!
Make sure the controller is in run mode.
For information about how to exit to run
mode, see section 10.4 Run mode > Exit to
run mode.
To register system devices in the controller:
1. Press and hold the OK button on the controller
until one of the channel LEDs starts flashing.
2. Use buttons < or > to move the pointer to the
power LED (LED flashes red).
3. Press the OK button to select system device
registration (power LED). The power LED starts
flashing according to the pattern long blink, short
pause, long blink. Channel 1 starts flashing red.
4. Use buttons < or > to move the pointer to the
preferred system channel, see list below.
1 = Touch screen interface (Base PRO only)
See section 8 Install Uponor Smatrix Base PRO
interface for more information.
1 = Timer
See section 7 Install Uponor Smatrix Base timer for
more information.
2 = Not used
3 = Public thermostat with outdoor sensor
4 = Public thermostat with heating/cooling switch
from sensor input (Base PRO with interface
only).
5 = Public thermostat with Comfort/ECO switch
from contact
5. Press the OK button to select system device
channel. The channel LED starts flashing green.
6. Public thermostat T-143 as a system device
6.1 Gently press and hold the registration button
on the thermostat, release when the LED starts
flashing green (located in the hole above the
registration button).
The selected channel LED in the controller turns
fixed green and the registration is complete.
7. Repeat steps 4 through 6 until all system devices
are registered.
8. Press and hold the OK button on the controller
until the green LEDs turn off to end registration and
return to run mode.
To unregister already registered sensors and switches,
see section 10.6 Unregister channels in controller.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
55
UPONOR SMATRIX BASE/BASE PRO · INSTALLATION AND OPERATION MANUAL

Uponor Smatrix Base Specifications

General

Brand	Uponor
Model	Smatrix Base
Category	Heating System
Language	English