Vertiv | SmartAisle2 | User Manual 89
Installation
2.10.2. Distribution Cabinet Electrical Installation
• Row from the output terminal of the distribution terminal cabinet, row zero line, and the ground are connected
with the discharge branch output line, neutral and ground respectively.
• The left and right sides of the cable tie beam line along the inside of the enclosure banding lines go up
piercing the distribution cabinet.
Figure 2-97 Tie beams and terminal position (rear view)
• For branch cable maintenance or issues related to this installation, quickly find traces on the recommen-
dations laid down line methods listed in the SPM user manual.
2.10.3. Electrical connection of the Rack PDUs
Distribution cabinet to one side of the line must be female and rack PDU to one side of the line must be male;
remember to take utmost care as any faulty connection may lead to serious injury or fatality. In case of any
equipment damage or severe injury or death, the customer is to be held accountable if the connections are
improper.
• The PDU rack cabinet power line should lead upwardly through the left inlet duct counter tops through holes
piercing from bobbin ferro-electric groove.
• Industrial male connector is mounted in a cabinet PDU cable termination
• Industrial female connector is mounted at the output branch cable distribution cabinet ends.
• Industrial male connector must be connected to the female plug.
To Next Page
Loading...
Need help?
General
