Xerox CopyCentre C123 User Guide

Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 User Guide 187
11 Setups
This chapter, aimed for the Key Operator, describes how to change various defaults
preset on the machine, how to register various items such as mailboxes and
destinations, and how to configure or change Key Operator settings.
System Settings Procedure
This section describes the basic system settings procedure. Follow the steps below.
1. Entering the System Settings Mode – page 187
2. Customizing the Settings – page 188
1. Entering the System Settings Mode
1. Press the <Log In/Out> button
on the control panel.
2. Enter the correct user ID using
the numeric keypad on the
control panel or the screen
keyboard. For information on
keyboard entry, refer to
Keyboard in the Fax/Internet
Fax chapter on page 81.
NOTE: The default Key Operator ID is “11111”. If the Authentication feature is
enabled, you may be also required to enter a password. The default password is “x-
admin”. To change the default user ID or password, refer to System Administrator
Settings on page 253.
3. Select [System Settings] on the
[System Administrator Menu]
screen.
NOTE: In [User Mode], you can
operate the machine normally while
logged in as the Key Operator.
<Log In/Out>
button

Xerox CopyCentre C123 Specifications

General

Brand	Xerox
Model	CopyCentre C123
Category	All in One Printer
Language	English