ABB ACS355 series User Manual

Actual signals and parameters 265
lb/s pounds per second 53
lb/m pounds per minute 54
lb/h pounds per hour 55
FPS feet per second 56
ft/s feet per second 57
inH2O inches of water 58
in wg inches of water gauge 59
ft wg feet on water gauge 60
lbsi pounds per squared inch 61
ms millisecond 62
Mrev millions of revolutions 63
ddays 64
inWC inches of water column 65
m/min meters per minute 66
Nm Newton meter 67
Km3/h thousand cubic meters per hour 68
min
Reserved for solar pumps
69
m3 70
m6 71
Reserved 72…116
%ref reference as a percentage 117
%act actual value as a percentage 118
%dev deviation as a percentage 119
% LD load as a percentage 120
% SP set point as a percentage 121
%FBK feedback as a percentage 122
Iout output current (as a percentage) 123
Vout output voltage 124
Fout output frequency 125
Tout output torque 126
Vdc DC voltage 127
3406 OUTPUT1 MIN Sets the minimum display value for the signal selected by
parameter 3401 SIGNAL1 PARAM. See parameter 3402
SIGNAL1 MIN.
Note: Parameter is not effective if parameter 3404
OUTPUT1 DSP FORM setting is DIRECT.
-
x…x Setting range depends on parameter 3401 setting. -
All parameters
No. Name/Value Description Def/FbEq

ABB ACS355 series Specifications

General

Brand	ABB
Model	ACS355 series
Category	Controller
Language	English