ABB ACS355 series User Manual

96 Control panels
 Assistants mode
When the drive is first powered up, the Start-up assistant guides you through the
setup of the basic parameters. The Start-up assistant is divided into assistants, each
of which is responsible for the specification of a related parameter set, for example
Motor set-up or PID control. The Start-up assistant activates the assistants one after
the other. You may also use the assistants independently. For more information on
the tasks of the assistants, see section Start-up assistant on page 121.
In the Assistants mode, you can:
• use assistants to guide you through the specification of a set of basic parameters
• start, stop, change the direction and switch between local and remote control.
How to use an assistant
The table below shows the basic operation sequence which leads you through
assistants. The Motor set-up assistant is used as an example.
Step Action Display
1. Go to the Main menu by pressing if you are in the
Output mode, otherwise by pressing repeatedly until
you get to the Main menu.
2. Go to the Assistants mode by selecting ASSISTANTS on
the menu keys and , and pressing .
3. Select the assistant with keys and , and
press .
If you select any other assistant than the Start-up
assistant, it guides you through the task of specification
of its parameter set as shown in steps 4. and 5. below.
After that you can select another assistant on the
Assistants menu or exit the Assistants mode. The Motor
set-up assistant is used here as an example.
If you select the Start-up assistant, it activates the first
assistant, which guides you through the task of
specification of its parameter set as shown in steps 4.
and 5. below. The Start-up assistant then asks if you
want to continue with the next assistant or skip it – select
the appropriate answer with keys and , and
press . If you choose to skip, the Start-up assistant
asks the same question about the next assistant, and so
on.
MENU
EXIT
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
00:00
LOC
MAIN MENU 1
ENTER
Start-up assistant
Motor Set-up
Application
Speed control EXT1
Speed control EXT2
EXIT SEL
00:00
LOC
ASSISTANTS 1
SEL
9905 MOTOR NOM VOLT
EXIT SAVE
00:00
LOC
200 V
PAR EDIT
SEL
Do you want to
continue with
application setup?
Continue
Skip
EXIT OK
00:00
LOC
CHOICE

ABB ACS355 series Specifications

General

Power Range	0.37 to 22 kW
Protection Class	IP20
Output Frequency	0 to 500 Hz
Braking Chopper	Built-in
Control Method	Scalar control, Vector control
Ambient Temperature	-10 to +50 °C
Communication Protocols	Modbus, CANopen
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature
Cooling Method	Air-cooled
Number of Phases	3-phase