ABB Advance Optima magnos206 User Manual

42/24-10 EN Rev. 9 Appendix 4: Index A-4-5
Index, continued
Pressure sensor 3-11
→ Air pressure correction
Profibus configuration 7-C-14
Profibus module
→ I/O modules
Pump
Activation 9-25
Activation during automatic calibration 8-B-4
Output adjustment 9-25
Purge gas 1-6
Purge time
for automatic calibration 8-B-4
Purging
during operation 5-5
prior to start-up 5-2
R
Reference gas
Flow meter installation 3-13
Flow rate 5-5
Relinearization (Limas11, Uras26) 9-8
S
Safety information xi, xii, xiii
ZO23 A-3-1
Sample gas flow rate 1-3, 5-5
Screen 6-2, 7-D-1
Configuring the bar display or
point display 7-D-9
Key entry 7-D-12
Configuring 7-D-13
Operating 6-11
Moving a display element
from one page to another 7-D-7
within a page 7-D-8
Page overview 7-D-4
Parameter overview 7-D-5
Screen overview 7-D-3
User page configuration 7-D-6
Value entry 7-D-10
Configuring 7-D-11
Operating 6-10
Serial number
of the system modules 7-C-6
Shipping 11-2
Sh ut down 11-1
Signal line connection 4-15
Single calibration 8-A-10
Single-point calibration
Caldos27 (with standard gas) 8-C-2, 8-C-3
Magnos206 8-C-7, 8-C-8
Softkeys 6-7
Software version x
Standard equipment 1-9
Standard function block applications
Connections 4-8
Standard terminal connections 4-9
Starting calibration 8-A-1, 8-A-4
Start-up 5-1
ZO23 A-3-7
Status
Process status 10-1
System status 10-2
Status LED’s 6-4, 10-4
STATUS MESSAGE key 6-7
Status messages 10-2
List 10-7
Status signals 10-4
Configuration 7-C-11
Substitute gas calibration 8-A-10
Caldos25 8-C-1, 8-C-4
Caldos27 8-C-2, 8-C-4
Magnos206 8-C-7, 8-C-10
Magnos27 8-C-11, 8-C-12
System bus
Connection 4-12
System controller A-1-3
System functions
Configuration 7-C-1
System housing A-1-4
Dimensional diagrams 2-4
System modules
Adding 7-C-7
Deleting 7-C-9
Replacing 7-C-8
Setting up 7-C-5
Continued on next page

ABB Advance Optima magnos206 Specifications

General

Brand	ABB
Model	Advance Optima magnos206
Category	Measuring Instruments
Language	English