300 Installation
Connection procedure
WARNING! Obey the safety instructions. See chapter Safety instructions on
page 13. If you ignore them, injury or death can occur.
1. Stop the drive and do the steps in section Electrical safety precautions on page 14
before you start the work.
2. Make sure that the FSO electronics grounding screw is correctly tightened. See
section Tightening torques on page 517.
3. Make sure that the enclosure grounding screw is correctly tightened. Use T10
head. See section Tightening torques on page 517.
To Next Page
Loading...
Need help?
General
