510 Maintenance
Replacing the FB module in PROFIsafe network
1. Replace the FB module according to the instructions in FPNO-21 PROFINET
fieldbus adapter module user's manual (3AXD50000158614 [English]), or
FENA-01/-11/-21 Ethernet adapter module user's manual (3AUA0000093568
[English]).
2. Assign the device name for the FB module from the safety PLC (see section
Configuring the ABB AC500-S Safety PLC on page 231 or section Configuring the
Siemens SIMATIC Fail-safe S7 PLC on page 249.
3. Update the revision and the serial number of the new FB module to the logbook of
the driven machine.
Replacing the FSE module
1. Disconnect the encoder connector and power supply connector, then remove the
FSE module.
2. Replace the FSE module according to the instructions in FSE-31 pulse encoder
interface module user's manual (3AXD50000016597 [English]).
3. Update the revision and the serial number of the new FSE module to the logbook
of the driven machine.
Replacing the safety encoder
1. If the new encoder is not identical with the old encoder: Make sure that the
encoder meets the requirements in section Safety encoders on page 43.
2. Install the new encoder according to the installation instructions given by the
encoder manufacturer and the instructions given in the FSO-21 module and
FSE-31 module user's manuals.
3. Make sure that the safety encoder related parameter settings in FSO-21 module,
for example, pulse count, are set according to the new encoder.
4. Do the start-up and validation procedures. See section Start-up and validation test
on page 510.
Start-up and validation test
1. Do the start-up procedure according to chapter Start-up.
2. Do the validation procedure for each safety function according to chapter
Verification and validation.
To Next Page
Loading...
Need help?
General
