Maintenance 509
423. If you download an old configuration, the new parameters will get the default
values. It is recommended to download, upload, and check the parameters.
6. Update the revision and the serial number of the new FSO module to the logbook
of the driven machine.
Reinstalling the FSO module to another drive
1. Install the FSO module and wiring to the new drive according to chapter
Installation on page 295.
2. Restore the drive parameter backup if available.
3. Download the correct safety configuration file to the spare part FSO module.
Replacing the control unit of the drive
1. Replace the control unit.
2. Install the FSO module and connect data and STO cables to the control unit.
Connect FSO IO connectors and power supply connector. If the memory unit is
installed back to the new control unit with existing drive firmware and parameter
settings, no other actions are necessary. If a new memory unit is used, the
configuration must be read and restored with Drive composer pro.
3. Do the start-up and validation procedures. See section Start-up and validation test
on page 510.
Replacing the memory unit or updating the firmware of the drive
1. Backup the drive parameter settings, if possible.
2. Download the drive firmware to the memory unit.
3. Restore drive parameter backup, if available.
4. Reboot the FSO module.
5. Reset the drive.
6. Upload and download the FSO configuration file if the drive firmware is updated
from an older version than 2.60.
Replacing a power unit, or its circuit boards or wirings
1. Replace the relevant part or power unit.
2. Do the start-up and validation procedures. See section Start-up and validation test
on page 510.
To Next Page
Loading...
Need help?
General
