5 Repair
5.1 Introduction
Structure of this chapter
This chapter describes repair activities for the IRB 1010. Each procedure contains
the information required to perform the activity, for example spare parts numbers,
required special tools, and materials.
WARNING
Repair activities not described in this chapter must only be carried out by ABB.
Report replaced units
Note
When replacing a part on the IRB 1010, report to your local ABB the serial number,
the article number, and the revision of both the replaced unit and the replacement
unit.
This is particularly important for safety equipment to maintain the safety integrity
of the installation.
Safety information
Make sure to read through the chapter Safety on page 15 before commencing any
service work.
Note
If the IRB 1010 is connected to power, always make sure that the IRB 1010 is
connected to protective earth and a residual current device (RCD) before starting
any repair work.
For more information see:
• Product manual - OmniCore E10
Product manual - IRB 1010 103
3HAC081964-001 Revision: B
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.1 Introduction
To Next Page
Loading...
Need help?
General
