130 Rockwell Automation Publication 2711P-UM007D-EN-P - December 2015
Chapter 6 Update Firmware
b. Select the location of the firmware card by browsing to the root
directory of the storage card that is loaded in your computer for
example E:\.
The firmware files are copied to this location. You can also specify a
folder on the hard disk.
c. From the Existing terminal type pull-down menu, select a PanelView
Plus 7 terminal.
d. Click Next.
4. Follow these steps from this dialog box.
a. Browse to the location of the firmware source files on your computer,
where the FUP was installed.
b. Choose the firmware version for the upgrade.
c. Click Next.
It can take several seconds for the next dialog box to appear while the
FUP is being retrieved.
5. From this dialog box, optionally select the KEPServer drivers that you
want included with the firmware, then click Next.
To Next Page
Loading...
Need help?
General
