36 Rockwell Automation Publication 2711P-UM007D-EN-P - December 2015
Chapter 2 Install the PanelView Plus 7 Standard Terminal
5. Apply power to the operator terminal.
Connect to a Network
The Ethernet port or ports connect to controllers on an EtherNet/IP network
by using standard Ethernet connections. These types of networks are
supported:
• Device Level Ring Network Topology
on page 37
• Linear Network Topology on page 38
• Star Network Topology on page 39
Each of these EtherNet/IP network topologies supports applications that use
Integrated Motion over an EtherNet/IP network, if necessary. See the
EtherNet/IP Embedded Switch Technology Application Technique,
publication ENET-AP005
, for more information.
Ethernet Ports
The Ethernet ports have one or two 10/100Base-T connectors for network
communication and supports MDI/MDI-X connections and DLR network
topology as indicated by the DLR network icon.
The terminal connects to an EtherNet/IP network by using a CAT5, CAT5E,
or CAT6 twisted-pair, Ethernet cable with RJ45 connectors.
ATTENTION: The earth ground connection to ground is mandatory.
This connection is required for noise immunity, reliability, and
Electromagnetic Compliance (EMC) with the European Union (EU)
EMC Directive for CE marking conformance. This connection is
required for safety by Underwriters Laboratory (UL).
IMPORTANT Secure the power cable to prevent these actions:
• Vibration at the connector.
• Pulling when the panel door is opened and closed, or when
personnel are working inside the panel.
IMPORTANT Series B terminals can have dual Ethernet ports, but only one device IP
address.
Link 2 Link 1
Series B terminal with dual
Ethernet ports shown.
Ethernet Ports
Link 1
Link 2
To Next Page
Loading...
Need help?
General
